Read Consulting

Materials Failure Analysis and Process Engineering

  • Home
  • About
  • Contact
FacebookTwitterLinkedinYouTubeRSS Feed

Home Featured

  • Experience
  • Failure Analysis
  • Processing
  • Laboratory
  • Blog
  • White Papers
You are here: Home / Archives for Tom Read

Porcelain Failure Analysis

October 9, 2012 By Tom Read Leave a Comment

California failure analysis lab is able to show similarities between glass failure analysis and porcelain failure analysis. The predominant tool for tracking a crack in glass is to look at “Wallner lines” These can tell the direction of travel of a crack in glass. This allows the glass failure expert to trace the crack back […]

Filed Under: Failure Analysis Tagged With: Porcelain, Porcelain Fracture

Failure Analysis Lab Examines a Failed Plastic Chair

October 1, 2012 By Tom Read Leave a Comment

California failure analysis laboratory performed a failure analysis on a failed plastic chair. A 190 pound man sat in it and the right leg broke under him. This was a brittle plastic failure that went along a molding weld line. The fracture surface shows brittle failure in bending.

Filed Under: Failure Analysis Tagged With: Chair, Plastic Failure Analysis, Plastic Pipe

Glass Expert Discusses Bend Test Fracture Surface

September 25, 2012 By Tom Read Leave a Comment

California Failure Analysis lab performed a compound bend test to determine if the failure surface can be at an angle to the surface. One curious result was a curved fracture surface. This occurs when the clamp on the topside (i.e. tensile side) was behind the support underneath. If the two clamped sides are aligned, the crack is […]

Filed Under: Failure Analysis Tagged With: Fracture, Glass

Glass Expert Performs Glass Bottle Failure Analysis

September 5, 2012 By Tom Read Leave a Comment

Read Consulting failure analysis lab was asked to determine the cause of failure of a small glass cosmetic bottle that had failed in on the filling line as the cap was being tightened. A glass failure analysis was performed using a low power microscope. The root cause of the failure was a chill check on […]

Filed Under: Failure Analysis Tagged With: Expert Witness, Glass, Manufacturing Defect

Glass Expert Discusses Modern Auto Windshields

August 8, 2012 By Tom Read Leave a Comment

California glass expert has been involved with evaluation automobile windshields. One way car manufacturers can  increase automobile mileage is to decrease weight. A part of this effort has been to reduce the weight of automobile windshields. This is done by reducing the thickness of the windshield. Upper left is a representative cross section of a […]

Filed Under: Failure Analysis Tagged With: Auto, Glass, Safety Glass, Windshield

  • « Previous Page
  • 1
  • …
  • 27
  • 28
  • 29
  • 30
  • 31
  • …
  • 61
  • Next Page »

Read Consulting Failure Analysis

Thomas L. Read, PhD,
1435 Fulton Road Santa Rosa, CA
Phone: 707-494-5089
email: info@readconsulting.com

  • Home
  • About
  • Experience
  • Expertise
  • Laboratory
  • Failure Analysis
  • Blog
  • White Papers

Read Consulting Failure Analysis

Thomas L. Read, PhD,
1435 Fulton Road Santa Rosa, CA
Phone: 707-494-5089
email: info@readconsulting.com

Connect With Read Consulting

FacebookTwitterLinkedinYouTubeRSS Feed

Registered Professional Engineer

Thomas L. Read, PhD., CEO
Registered Professional Engineer
Certificate No. MF002174
State of California.

Copyright © 2025 Read Consulting · Materials Failure Analysis And Process Engineering